June 22, 2018

Tag Archives: FirePOWER

Cisco :: Upgrade or Reimage Firepower 8300 Sensors?

Recently I was tasked with upgrading some new Firepower 3D8350 sensors which would later be stacked into a 3D8360. These devices were shipped with software version 5.4.0.1 and I had a customer requirement to upgrade the sensors to version 6.2. I would normally stack these devices and upgrade them using the FMC, however, I didn’t […]

Cisco :: ASA to FTD Migration Tool

  In this article, I will demonstrate how to leverage the Firepower Management Center (FMC) to covert Adaptive Security Appliance (ASA) configurations to Firepower Threat Defence (FTD) configurations.  Using the ASA to FTD migration tool can save ample amounts of time, especially if you wish to carry over ASA ACLs and NAT rules. Before I get […]

CCIE Security v5 :: Adding Remote FTD Device To The FMC

In this article, I wanted to demonstrate how we can add a Firepower Threat Defence appliance to an FMC located at another site. Let’s take a fictitious scenario to provide some context to why and how we configure the FTD device the way we do. Scenario Currently Synack Corp has one Firepower Management Center (FMC) […]

CCIE Security v5 :: Adding Devices to FirePOWER Management Center (FMC)

This article is intended to cover some of the topics listed within the ‘Perimeter Security and Intrusion Prevention’ section of the CCIE Security v5 blueprint. This article focuses on configuring compatible devices to be managed by the FirePower Management Center (FMC). It is assumed that devices are already installed and you have access to the FMC […]

Subscribe to SYNACK via Email